SPECTRA
Patterns is meant for heat transfer onto a variety
of materials including cottons, polys and poly/cotton blends. It is a 15” wide
material. Not only does this material apply to light
colored fabrics, but it also pplies to dark colors as well. Very thin and soft hand.
Remember to mirror your image or design
before cutting it.
Application Instructions:
1) PREHEAT GARMENT - Preheat garment at a
temperature of 330º F for 4
seconds to remove moisture and wrinkles.
2) HEAT APPLY - Apply SPECTRA™ Patterns for 12 seconds at a temperature of 325º
F using MEDIUM pressure (4-6 pressure
reading if you own a Phoenix Phire or Hotronix Heat Press that offers live
digital pressure). PEEL HOT.
3) COVER - Cover the applied design with a teflon
sheet and heat apply again for 5 seconds at same
time and temperature.
PEEL HOT.
CARE INSTRUCTIONS:
** Turn garment inside out & machine wash in warm or cold water - mild
detergent. 122 F max. temp.
** Do not iron directly onto this material.
** Do not bleach.
All
technical information and recommendations are based on tests we believe to be
reliable. However, we cannot guarantee performance under conditions not under
manufacturer's control. Before using, please determine the suitability of
product for it's intended use. The user assumes all risk and liability
whatsoever in connection with the use of this product. Seller's and
manufacturer's only obligation shall be to replace such quantity of the product
proved to be defective by the manufacturer.
|
